To program autopage

We all need to let other people operate our vehicle at some point or another. Whether it's a valet at a restaurant or a mechanic at your local garage. With valet mode, you can disarm your alarm and hand the keys over without the worries of handing over your alarm system. How do I turn on valet mode? Valet mode can be entered in a couple of ways. Turn the vehicle key in the ignition to the 'On' position. Holding the buttons for over. Does a valet key have a chip?

Yes the valet key has a chip in it that is coded to your immobilizer. How do you program a valet remote start? What is valet mode on Range Rover? Valet mode allows the vehicle to be driven and locked by a parking attendant, without giving access to the loadspace. Valet mode also prevents operation of the Touch screen, to prevent access to telephone numbers or navigation addresses.

What is an example of hypothesis testing? Is Apple a tertiary sector? Co-authors 8. Pyle Car Alarm Security System. Why did my remote start stop working? Cause: In most cases, the under-hood pin switch is broken or corroded. Any remote starter must have a method of preventing the vehicle from starting when the hood is open.

Without this, a mechanic could be seriously injured if the vehicle was remotely started while they were working on it. How do I reset my remote starter? How to Reset a Remote Starter Enter your car with your starter and ignition key and leave the driver's door open.

Insert your key into the ignition and turn it to the "On" position. Press and hold the "Valet" button on your remote and wait for the horn to chirp. What is valet mode Viper? What is Valet Mode? We all need to let other people operate our vehicle at some point or another.

Whether it's a valet at a restaurant or a mechanic at your local garage. With valet mode, you can disarm your alarm and hand the keys over without the worries of handing over your alarm system. How do I turn on valet mode? Have the remote starter and your ignition key in hand.

Insert the key into the ignition and switch it from "Off" to "On" three times, ending in the "On" position after the third cycle. Push the valet switch on your Autopage alarm twice.

Hold the button on the second push until you hear a chirp, signifying that the programming sequence is ready. The valet switch is located near the bottom of driver's dashboard, where the alarm is set up. Press any button on your keyless remote starter. The vehicle will respond with another chirp to indicate that the programming was successful. Turn the key in the ignition back to the "Off" position once you have finished to end the programming sequence. Insert the key into the ignition of your vehicle and turn the key to the "On" position.